![]()
1400 Vandiver Dr. - Columbia, MO 65202
573-474-5500 fax 573-474-5606 rivermist.com
Every Three (3) months:
Drain your spa, clean, and protect the surface with Plexus polish
Inspect all jets, remove & clean as needed
Install clean filters, soak 10–12 hours in EZ Filter cleaner & rinse
Fill spa with water to manufactures recommended level
Turn on breaker, check pump(s) for air locks
Fresh Fills:
8 oz Metal X with jets on
2 to 4 tablespoons of Sani-Spa chlorine
Test pH and alkalinity using strips
Balance water by adding no more than 2 oz of up or down at a time
Allow 30 min. intervals between, adjust to 7.4–7.6 and 80–120 ppm
Alternating days per week: Mon-Wed-Fri
Test the water using strips (check more often if necessary)
Adjust pH & alkalinity to 7.4–7.6 and 80–120 ppm
Maintain chlorine level of 3 – 5 ppm
Once per week: Not to be done on same days
2 oz Metal X with jets on low to mix
2 oz. Spa Shock, cover off with jets on high for 40 minutes
1 oz Super Blue water clarifier, jets on high 20 minutes
(for best results, pre-dilute product in mixing cup)
After each use:
Broadcast +1 tablespoon Sani-Spa per bather
(do not exceed 5 tablespoons per day)
Cloudy water, increase use of Super Blue to 1oz “twice” per week
Foaming, use Suds-X to suppress, then remove with Super Blue
First week of each month:
Test strips Filter Cleaner
pH Up & Down Suds X Defoamer
Sani-Spa, chlorine Alkalinity Up
Metal X Scum Digester
Spa Shock Sea Klear Clarifier
Super Blue